Search Documents

By R. R. Tatiya

The following procedure was used to determine cut-off grades: define the orebody profile; plan the stope layout and quantify the work involved; formulate equipment-performance norms; calculate unit costs; input process recoveries and metal prices; and calculate the cut-off grade. Use of the method is illustrated using data from a copper mining complex in India. Results from the study led to the following conclusions for underground mines in general. Cut-off dependent costs vary significantly with the stoping method employed, orebody thickness, the degree of mechanisation and the working efficiencies of the workforce and equipment. This applies even within the same deposit. Sub-level stoping and its variants can be operated at a lower cut-off grade than cut-and-fill and its variants. Thinner orebodies affect cut-off grades adversely, but with thinner orebodies very little further reduction in cut-off grade can be achieved once a certain minimum width has been exceeded. For the same stoping method and in the same mine the cut-off grade varies with the degree of mechanisation. Labour-intensive methods require higher cut-off grades. An allowance for working efficiency should be made when calculating cut-off grades. Higher process recoveries allow a significant lowering of cut-off grades

Jul 1, 1996

By N. T. Moxon, D. Mead, S. B. Richardson

A laboratory and theoretical study of air decks was carried out to assess the effects of the size and location of air-decks on fragmentation. The degree of fragmentation was found to depend on both factors. As the size of the air-deck increases the degree of fragmentation is reduced relative to a full column charge. However, the reduction is relatively small until a critical size is exceeded. The critical size depends on the strength and structure of the surrounding material. A critical air-deck length of 30-35% of the original explosive column was determined for the model materials used in the study. A theoretical explanation of the results was derived based on pressure decay rate relationships. The location of the air-deck also influences fragmentation. The interaction and oscillation of the two shock fronts from the top and bottom charges mean that mid-column air-decks produce better fragmentation for the same air-deck length and explosive loading as top-column or bottom-column air-decks.

Jan 4, 1993

By J. Gough M. D.

There are many points still obscure regarding the nature of coal-workers'- pneumokoniosis, but the interpretation of the disease has been greatly clarified in recent years. It is now known that exposure to fumes or gases or other conditions peculiar to coal-mining are not necessary factors in the production of pneumokoniosis. The same disease occurs in coal-trimmers working in the docks, and it is thus established that the inhaled dust is the primary factor. On the other hand, there is no completely satisfactory explanation of the distribution of the disease. Geological and petrological studies have not given an unequivocal explanation of the difference in incidence in different parts of the coalfield. It is an open question whether the quantity of dust inhaled is more important than its chemical composition. However, there is ample evidence from the medical side that elimination of dust and of tuberculosis from the environment of coal workers will be required to prevent pneumokoniosis. Much is being done with regard to elimination of dust, and a similar energetic action is required in regard to tuberculosis.

Jan 1, 1947

By G. Richards

Application of the Internet of Things (IoT) technologies - the interconnection of uniquely identifiable embedded computing devices within the existing internet infrastructure - to the mining industry is discussed. IoT technologies are aimed at making projects safer, better optimised and more economic and are applicable to current or new underground or open-pit mines, regardless of size. Two examples are presented of successful implementation of IoT technologies, the Chelopech gold, copper and silver mine in Bulgaria, where production has increased from 500 000 to 2 000 000 tonnes/y and communication costs have been reduced by US $2 500 000 over 2 y, and the Pilbara project in Western Australia, where remotely controlled wirelessly connected autonomous trucks have covered ca. 3 000 000 miles and hauled almost 250 000 000 t of ore since 2008

Apr 1, 2015

By K. El-Barawi, Hussein M. Kamal

Chlorination was performed of iron-rich chromite ore from Barramyia, United Arab Republic (UAR), together with its concentrate. The effects of change of grain size, chlorine gas flow rate, time and temperature were studied. The extent and mechanism of chlorination were followed through chemical and structural analyses of the feeds and complete chemical analysis of the chlorination products. By conducting the chlorination process for short periods at 600°C or lower temperatures, products having high Cr-Fe ratios suitable for ferrochrome production can be obtained.

Dec 1, 1971

By M. A. Bussell, G. S. Camm

The study included lode zones at Wheal Pendarves, South Crofty and Rosevale tin mines. Fluid inclusion-containing microfractures are a common feature of the granites and typically show a preferred orientation over quite a large area. The close proximity of a dominant vein or fault controls their density and orientation. They are important pathways for fluids and provide a marker for palaeo-fluid flow. Overprinting provides a reliable representation of the evolution of the hydrothermal fluids in a vein system from early magmatic fluids to late-stage meteoric and basinal brine input. Measurement of microfracture orientation allows estimation of the regional stress regime during a specific hydrothermal event. Since micro- and macro-structures can generally be reliably correlated, these studies assist in modelling the detailed development of complex vein systems. Microfracture density is a good measure of palaeo-permeability, with implications for control of wallrock alteration. The determination of the location and density of microfractures can assist the mine geologist in identifying the location of potentially economic vein structures where macroscopic markers are absent

Aug 1, 1996

By H. L. Willett

The self heating of coal, or spontaneous combustion, has been a problem for centuries. This symposium addresses the issue.

May 23, 1905

By R. Immele-Meziou, G. J. Long, D. G. C. Robertson, O. A. Pringle

The reduction of naturally weathered ilmenite concentrate occurs in two steps: reduction of Fe3+ to Fe2+, followed by reduction of Fe2+ to Fe. Small amounts of a magnetic phase were also observed and may correspond either to an Fe3O4-FeTiO3 ilmenite phase or to an Fe3O4-Fe2TiO4 spinel phase. The total amount of metallic iron produced after 12 hr was only 50% of the total iron present in the sample.

Jan 4, 1992

By R. H. . T. Garnett

Contributed remarks on paper published in the Transactions, Mining industry section, vol. 100, September- December 1991, A121--45

Jan 12, 1992

By J. P. Rees

Describes methods of dust-sampling such as weighing the dust caught on cotton-wool, the sugar tube, konimeter, circular konimeter and the thermal precipitator. Covers the work of mine dust inspectors, the Miners' Phthisis Prevention Committee and the Chamber of Mines Dust Department.

Jan 1, 1947

It was intended to show a film on Dust Suppression in the South Wales Coal-mines. Unfortunately, owing to a breakdown, only a small portion of the film was shown.

Jan 1, 1947

By F. G. Bell, S. E. T. Bullock

The investigation was undertaken as part of the environmental management programme that must be implemented on mine closure. It involved sampling and analysis of water from boreholes, the tin mine workings, trenches and pits as well as soil and dumps. Both ground- and surface water in the immediate vicinity of the mine was found to have been affected to varying degrees, mainly due to acid drainage from the pyrite dumps. Metal ions and toxic salts are taken into solution with increased acidity and precipitated in the soil when the pH rises again; there are concentrations of metal ions in the soils around the main dumps, but these do not seem to pose a major threat in a regional context. The low groundwater gradients, together with the dyke system in the vicinity of the main dumps and the impermeable nature of the Boschoffsberg rocks, make it unlikely that affected groundwater will migrate further than 1 000 m to the north and north-east. Nonetheless, it has been decided to remove the pyrite dumps

Dec 1, 1995

By D. H. Watkinson

Paper presented at the IAGOD international symposium on mineralisation related to mafic and ultramafic rocks held in Orleans, France, 1-3 September 1993. Part of the contact of the 4b orebody with the enclosing Murray granite is characterised by the presence of recrystallised and biotitic Sudbury Breccia; in places the contact is faulted and sheared. In other areas of the contact partly silicified granite contains disseminated chalcopyrite and quartz-chalcopyrite veins with other minor minerals. Both ore and veins contain platinum group minerals (PGM); predominant PGM are michenerite, kotulskite, merenskyite and sperrylite with Au, galena and Bi-tellurides. At some silicified-granite contacts Mn-rich garnets, some containing inclusions of PGM and quartz, are associated with biotite + epidote + stilpnomelane + quartz. PGM and Au also occur within Cl-rich biotite and ferropyrosmalite in massive sulphide and in siliceous ore. Quartz, chalcopyrite and feldspar in the contact rocks and in veins contain abundant, highly saline fluid inclusions. Studies showed that the fluids were trapped at intermediate temperatures. The 4b orebody is surrounded by a sheath of brecciated granite but is close to the Contact Sublayer. During and after emplacement of sulphide magma, saline formational fluid that was resident in the breccia interacted with hot massive sulphides in and near the Sublayer and remobilised Cu, Au and PGE. This fluid reacted with cooler rocks and ore in footwall fractures, enriching the 4b protore and producing the adjacent Cu- and PGE-enriched quartz veins. Exploration for Cu and PGE enrichment in footwall rocks of the Sudbury South Range is warranted not only in zones of magmatic ore in the Contact Sublayer but also in fractures and permeable units within Sudbury Breccia

Jun 16, 1905

By L Casari

A study of samples from three sectors of the mine, which was worked from Roman times to 1991, revealed different textures, mineral associations and distributions of trace elements in the sulphides. In the last decade before closure, grades of sphalerite concentrate were in the range 51.67-53.30% Zn and 2.21-2.86% Pb and of galena concentrate 69.43-71.62% Pb and 4.70-8.36% Zn, while the estimated by-product germanium content of sphalerite concentrates sold was 300-400 g/t. Passing the different run-of-mine materials through the same concentrator flowsheet produced middlings and tailings during the preconcentration processing. Separate and alternative treatment of run-of-mine products would have yielded improved recoveries of sphalerite and galena and better values of by-product germanium and cadmium

Jun 18, 1905

By Ruddle R. W.

The slags produced in copper smelting are largely composed of silica and ferrous oxide and may therefore be regarded as essentially ferrous silicates. A fair amount of information is available on the constitutions of the liquid slags used in copper smelting and, in this connection, the large volume of work being carried out on steelmaking slags should be helpful. Constitutional diagrams are available for most of the principal systems involved (SiO2-FeO; SiO2-FeO-Al2O 3; SiO2-FeO-CaO; SiO2-FeO- MgO; and SiO2-FeO-CaO-Al2O3) and these show that additions of Al2O3 and CaO reduce the freezing points of SiO2-FeO slags but that additions of MgO increase the freezing point. A certain amount of information is available on the thermodynamics of slags, but much further work on this subject is required. Modern theories of the constitution of liquid slags deny the existence of molecular compounds but consider that liquid slags are mixtures of various ions such as, Fe2+. O2- and SiO4(4-). Little appears to be known of the reactions between matte and minor constituents dissolved in the slag

Jan 1, 1953

By I. Garba

The Bin Yauri deposit in the Zuru schist belt of northwestern Nigeria is a vein-type quartz-sulphide-carbonate gold mineralisation hosted by a brittle fault zone. The occurrence of the mineralisation in a contact zone of a Pan-African granitoid was believed to be sufficient evidence of deposition from magmatic fluids. However, studies may now indicate a metamorphic source for the mineralising fluids. A study of rare earth element geochemsitry was used to investigate the nature of the fluid-rock processes involved and identify the sources of the auriferous mineralising fluids.

Jan 12, 1992

By NA NA

Profile of FOSROC, manufacturers and suppliers of products for the mining industry.

Jan 11, 1996

By T. Guyaguler

An analytical technique using computer-based multiple-regression methods was employed to determine the relation between the dust-producing index and inherent rock properties of typical samples from a coal-producing area, one of the aims being to provide a preliminary predictive tool for practical use. The investigation demonstrated that factors varied in their influence under different conditions, the brittleness:toughness ratio and the hardness being the most significant inherent properties with hardness showing the highest positive correlation coefficient

Jun 13, 1905

Papers submitted at the 8 ordinary general meetings are listed and details given of the proceedings of the annual general meeting held on 20 May 1971

Dec 1, 1971

By D. L. Buchanan, ed. sci.

The issue comprises 10 contributions on PGE mineralisation, of which 9 were presented at the symposium organised by the IAGOD Commission on Ore Deposits in Mafic and Ultramafic Rocks and the BRGM-CNRS University of Orleans research group. The editor's introduction and summary of the papers is presented together with the title page, contents list and cover photograph of a harzburgite ridge, dunite boundary and chromite quarry in the Shetland ophiolite on Unst

Apr 1, 1994